Support us on Patreon: https://www.patreon.com/woodshoplife
Sean
1) If I wanted to try my hand at veneering my own panels, what set up process do you recommend? This would be an attempt to do it without diving in and purchasing what I hear you guys talk about as a vacuum bag. Is it even possible to veneer my own panels without a vacuum bag? Matthew
2) Hey guys thanks for a great podcast and for answering questions from all of us. I have a question about planers. I am looking to upgrade my lunch box planer to something that is better than what I have now (ridgid 12.5″). I had a 15″ planer years ago and am wondering if I “need” a large planer (15-20″) or would something like the Dewalt 735 work just fine? Thanks for your input. Troy
Guy
1) Thanks to you all for the wonderful podcast. Really enjoy the way you discuss our (sometimes dumb) questions with great care. I appended my question to an earlier message, but I don’t think it got answered. (If it did, please just re-direct me?) I was finishing up a console made of red oak lately with a couple coats of shellac followed by 3-4 coats of Total Boat Water-Based Poly. Again and again, I’d put on a coat of the poly that looked completely smooth only to come back to what looked like dirty grey raindrops with long tails — not the look I was going for my beautiful sandy red oak piece! I was using a foam brush to apply. I didn’t see any of these trails when I was putting on the finish. And it happened on both horizontal and vertical surfaces I finished. Is this a well known problem with water-based poly? Is it my brushes? But most importantly, is there a way to avoid it? I loathed having to sand it back and reapply. Also, while you’re at it, is it worse to finish things vertically rather than horizontally because it the finish might collect and drip down? Thank you for your thoughts! (Oh, and tell Guy that he never needs to apologize for giving his “opinion”. Frequently, it’s not just an opinion but a position arrived at from lots of expert observation!) Adam Potthast
2) Hey guys, thanks for always producing such great content. My question is about dovetails for beginners. I’ve never done dovetails before, but recently purchased the Leigh through dovetail jig TD330 and am eager to get going. What tips, tricks, and general words of wisdom would you give someone who is just starting to work with dovetails? I know that’s super open-ended so here are a couple specific questions to get the juices flowing- I see that this jig can be used with a handheld router or a router table. Do you have a preferred method when making your dovetails? I’ve also heard people say to buy extra material when starting to work with dovetails, but how much extra? If I’m making a box, should I plan to buy enough materials for 6 sides (basically giving myself 2 extra box sides in case of screw-ups)?
Thanks again for all the great shows. I’ve learned so much from you guys and really appreciate it. Billy
Huy
1) Hey guys! Quick question – I like to resaw turning blanks to make small boxes and they often come covered in wax (or something). When I receive them, should I scrape off the wax immediately and let them acclimate to the shop? Or wait until I’m ready to mill them? Also, what’s the best way to do that? I was thinking skim-cuts on the table saw. Thanks!!
Dan
2) Which type of router would you suggest for fitting to a router table?
I imagine that if I buy a plunge or fixed type and mount it to a table and I can always take it out and use it handheld etc but with a motor body I can leave it set up and just purchase a plunge type as well ( more tools is always a good thing) -Geoff
