Support us on Patreon: https://www.patreon.com/woodshoplife
Guys Questions:
1) Hey guys. Love the pod! I have I think an easy question. This is my first project with hard woods other than poplar trimming. So here it goes…
I am making one of those balancing wine holders as a birthday gift but I want to dress it up a bit. I have a piece of hard maple. I want to frame the maple with a .5” -.75” strip of Purple Heart around it, mitered in the top corners. The overall dimensions will be about 15” x 5.5” My question is this. The top piece of Purple Heart would be running the grain perpendicular to the maple. Is this a bad idea? Should I cross cut that strip of PH so all the grain is running the length of the piece? -Jonvigorito
2) Thank you so much for putting out this podcast, it’s made my boring commute to work a whole lot more enjoyable!
My question is, what are your thoughts on using the Metric system in your shop? As an American woodworker, I primarily use Imperial units for measuring, but have found it easier to switch to Metric for certain tasks like dividing a space by an odd number.
Thanks again,
Justin
Seans Questions:
1) Wondering what you guys recommend for a good doweling jig, that can do both wide and thin stock? Also your opinion on the Triton Dowel jointer. – Christopher
2) Hey guys just started listening to your show, I’m new to woodworking and every episode I’ve learned something new from you guys. Love the show. I’m starting to work with hardwoods for the first time, been wanting to make cutting boards, coasters, cigar ash trays etc. looking into Thin Kerf blades but don’t know much about them. So my first question is are they necessary, and secondly which ones do you suggest(more on the low end of price) I’ve looked at Freud 10” 24T Ripping Saw & Amana Tool Mamba Series MA10024 Thin Kerf Ripping 10-Inch x 24 Tooth. Thanks in advance – Tom(Tom_the_Builder_17 on ig)
Huys Questions:
1) Hey guys! I have a question regarding hand planes/Electric hand planes…
I am looking at buying an electric hand plane (likely the Triton 3 blade unlimited rebate planer) instead of a nice Veritas low angle plane. I don’t finish with a card scraper or smoothing plane as I haven’t had enough practice, yet I am very pleased with the results I get sanding. Am I crazy to think that an electric hand plane will do a great job at taking down high spots, to flatten a table top over a finely tuned hand plane? I’m finishing by sanding, so I don’t need the plane to leave a glassy smooth surface. I need the high spots gone and gone quickly. I ask because I don’t see many other woodworkers using this method, but in my mind it seems much more efficient (if finishing by sanding). I’d love to hear your response on the podcast. Nobile builds
2) Hey guys, I’m expanding my sharpening set up, and looking to add a grinder for initial squaring and hollow grinding. I am looking at cheap options and I’m torn between a slow speed 8 inch grinder, or the cheap wet grinder made by WEN. Do you have any recommendations or suggestions? Zacs wood studio
