Support us on Patreon: https://www.patreon.com/woodshoplife
Guys Questions:
1) Would also like to get either an Incra Miter Sled or Miter Gauge. I see they have a sled/gauge combo or a sled with an integral miter gauge. Can you discuss the pros and cons of each option? – David
2) For Router table use is there really a difference when using a pattern bit vs a flush-trim bit when you want to flush an edge up with a template? Does riding the bearing on top vs on the bottom cause any safety concern? Does one leave a better/worse edge or does it even matter? Thanks, Ryan
Seans Questions:
1) Hey guys, love the podcast. Especially listening to guy, because I feel like I’m listening to myself from the future. In response to your recent call for more questions, I have one about tool sharpening. Specifically, what kind of honing jig to buy. I see there are a lot of them out there, but do you have any recommendations on a specific one to get. I’m getting into more hand tool work, and I want to be able to maintain my own chisels, as well as restore some old hand planes that I have. Any advice you may have is much appreciated. Thanks again for being willing to share your knowledge and experience. -Tavis
2) You’ve mentioned some of the books you’ve relied on, and I appreciate that, since I’m a green-as-grass beginner, and benefit from any source of information I can get. I’d also like to hear you talk about what mentors or teachers you had who helped shape your skills. Have any of you taken formal classes or gone to woodworking schools? I know that the best way to develop skills is by building furniture and learning from mistakes, but I also hope to participate in a class sometime, if only to find an active woodworking community. – Martin
Huys Questions:
1) I’ve recently bought a good planer/jointer combo machine. It uses 3 planer knives in the cutter block. I won’t be using it enough to consider an upgrade to some sort of helical cutterhead. So I’ve been thinking about a practical way to sharpen the knives. I’ve come to a jig, some sort of wooden block with an insert for one knife. The top surface of the block is tilted in such a way that my water stones have support for the correct angle when I use them to sharpen the edge.
The jig works, but I wonder if there is a more practical (faster) way to sharpen. I see that Tormek sells a sharpening system that does this, but since it costs more than the helical cutter block, I find that too expensive.
My question: do you know of an affordable sharpening system for planer knives (mine are 10″ long)? – Bart
2) Looking at finishing the top I was going to use epiphanies spar varnish but was wary of using this finish because of UV resistance. Would this inhibit the natural darkening of Cherry? My other option was General finishes ARM R seal or Waterlox. I don’t have way to spray so conversion varnish is out of the question.
My other thought was to dye the slab with Lye and use the Epifanes.
Keep up the good work.
Thanks
Jesse
Beechland Furniture
Social Picks
Guy: @kingposttimberworks
Sean: @hawthorne_fine_boxes
Huy: @affinecreations
