Support us on Patreon: https://www.patreon.com/woodshoplife
Sean
1) Hi, I just joined as a new patron and my name is Dale. I have been listening for a couple months and have tried spraying shellac on ambrosia maple. I sanded with 400 grit between each of 3 coats, then I sprayed a water based polyurethane as a final coat. I am new to spraying but what I found was that all of the vertical surfaces turned out great but I got a lot of nibs on the horizontal surfaces. Any idea why? -Dale
2) Going to be using General finishes Gel Stain on small toy chest. I’ve heard two different methods to prevent blotches; apply a mineral spirits slip coat prior to staining or apply shellac prior to staining. Is one better than the other? Thank, Brandon
Guy
1) Guy since you started working in the other, more commercial, shop:
How did working there change your behavior in your own shop? Are you faster now? Do you still treat your own projects the same way you did before working there?
Cheers from Austria, max
2) Hey Guys (and Guy specifically). I’m looking to possible build another router table (already have one in the wing of my table saw and love it) but being that I am for the time being in a smaller shop that everything has to be put away at night I need multi function. Looking at how the LS attaches to the table I was thinking I could remove the positioner (and put it on the wall) when not in use. Am I killing the whole function of the repeatability if I take it off and put it back on when I want to use it? Thank you, Doug
Huy
1)I have Question on wood glue. Usually I use Titebond but on the bottle it says it shouldn’t be used in temperatures lower than 50 degrees. So are there any glues that work in temperatures below freezing? My shop has no heat and the I’m in northern Iowa so we’ll go below zero before the winters over. Thanks for any advice you may have, keep the podcasts coming.
Josiah
2) Hi guys, first of all I sure have enjoyed your podcast and I have learned a tremendous amount. On a sidenote, my goal is to be just like Guy someday and be in a position in life to do whatever the hell I want and not give a damn what anybody thinks of me. I think it’s a noble goal. My question involves face joining boards. I wonder how much pressure I’m supposed to be pressing down on the board as it comes over the knives. Do I push down hard enough to take the spring out of the board? Or do I let it coast over naturally as to not take the spring out of the board? If I put too much pressure on the board it just springs back after it comes off the machine. But if I don’t put enough pressure on I don’t get clean results. I sure appreciate your help, and I look forward to hearing your answer. — Bill
Thanks to this show’s sponsor: Maverick Abrasives
